Clutch Cable Snapped

[Phrozen]

Hi all.

Today I was going along the road and my clutch cable snapped on my RS125.

I took the small plastic covers off of the Gearbox Casing, grabbed a spanner and tried to undo what i think is the adjuster bolt, and I think i've broken it!

Now when i pull the clutch, it doesn't trigger back

I havn't attempted to start the bike again just incase i cause further damage.

I've attached a picture to this thread so you guys know what i'm on about.

Any help would be much appreciated!

Thanks!

[chrisnorman83]

I'm sure you have worked this out by now. In case you haven't taking the old cable out and putting a new one is easy as pie. if you undo the the top filler cap where you put your gear oil in you will actually be able to see the cable. Simply push the cable further into the gearbox and pop it off the bracket through the little fill hole once you have done this you can pull the cable straight out of the gearbox. It's the same in reverse to put the cable back on though it takes a bit more fiddling and the use of screw drivers through the fill hole to get it back on. you can email me if you have any questions about it.
Chris